Below are a few videos to get you started with your new xSPINE. Look back soon for more content! And if you have any questions, don’t hesitate to email us!
See below for installation instructions for the Easyrig Vario 5 and Cinema 2.5/3 mounts for the xSPINE.
It’s very important to adjust the xSPINE to fit your body. Start by downloading the xSPINE Fitting guide to adjust your vest to a good starting point, based on your measurements. Read the fitting guide, and have a look at the videos below for more info. If you need any further help, don’t hesitate to send us an email!
5 hours ago
The xDROP, is a new male socket block-to-female socket block connection bracket, that drops the arm connection to the vest approx 85mm or 3.4″ and offsets the same connection to the side 55mm or 2.2″. It works with all universal steadicam type vests.
.
Creates more space between the operators gimbal controlling arm and his/her articulated stabilizer arm connection, resulting in better freedom for the operators arm as well as better space between the vest, arm and sled.
.
The female socket end allows of a greater tilt adjustment angle (up to +/-16.5 degrees, depending on male socket block) than traditional ones, also since you can now adjust this from both female socket blocks end you have a lot more tilt adjustment.
www.flowcine.com
.
.
.
.
.
.
.
.
.
.
.
.
.
.
#filmcrew #flowcine #arri #cameragear #flowcineoperator #cameragear #Xspine #stabilized #flowop #flowoperator #flowcine #cameragear #behindthescenes
#Xarm #xr3ach #Xdrop #flowoperator #gpipro #steadicam #flowoperator #exovest #steadicamoperator #steadicamop #camera #cinematography #Xarm @behindthescenegram @learnfilmmaking @filmakrs @filmschool @cinematogr @filmingtoday @steadigram @behind_the_cameras @filmmakaz ... See MoreSee Less